Page 1 of 1

error with hypersynth

PostPosted: Sat Jan 07, 2012 3:46 pm
by robleighton22
hi there,

i hav a very annoying issue with hypersynth. when changing a parameter a few times, the patch on the miniak randmomaly changes. i hav on several occasions returned to the patch i want to edit and again, when moving the parameters on hypersynth, the patch changes again. this makes it impossible for me to edit the synth using hypersynth?

any ideas?

Re: error with hypersynth

PostPosted: Sun Jan 08, 2012 8:07 am
by Iman_JL
You should look for the problem somewhere else in your MIDI chain, host settings or the Miniak itself. The only parameter that generates "program change" message is the bank\program knob which is located under MIDI IN device. Maybe it is automated by your host or linked to an external MIDI controller.

On your Miniak press Config>MIDI "Pgm Change" and set it to OFF mode and see what will happen in this situation.